Article ID : 00247590 / Last Modified : 24/06/2020

How to change table top stand height and position after set up

    IMPORTANT: This article applies only to specific products and/or operating systems. Check Applicable Products and Categories for details.

    Before you start

    • The steps in this guide require three people or more.
    • Make sure an adequate number of people are used to safely support the TV.
    • When you lift one side of your TV, make sure the opposite side doesn't drop to the floor.

    A8, XH95 (55, 65, 75), XH90 - XH91 - XH92 series TV

    1. Remove the stand from the TV.

      Removing the stand from the TV

    2. Support the bottom of your TV with a suitable material such as a stack of newspapers or magazines. The illustration shows the approximate size (width, height, and depth) of the recommended support material.

      The appropriate material size to put under the TV. A: Width, B: Height, C: Depth

      TV SeriesUnits are in inches
      [A] Width[B] Height[C] Depth
      A8H16-24Approx. 88 or more
      XH950 (55, 65, 75)16-24Approx. 108 or more

       
    3. Reattach the stand to your TV in the new position.
       
      • A8 series

         

      • XH95 series (55, 65, 75) XH90 - XH91 - XH92

         


    ZH8 series TV

     

    1. Remove the stand from the TV.

      removing the bolts

    2. Support the bottom of your TV with a suitable material such as a stack of newspapers or magazines. The illustration shows the approximate size (width, height, and depth) of the recommended support material.

      The appropriate material size to put under the TV. A: Width, B: Height, C: Depth

      TV SeriesUnits are in inches
      [A] Width[B] Height[C] Depth
      Z8H16-24Approx. 18 or more

     

    1. Reattach the stand to your TV in the new position.
      • The image below is an example. For more information, refer to the Setup Guide included with your TV.

        wide stand

        narrow stand