Article ID : S700023635 / Last Modified : 12/07/2018Print

How to replace the SR Series keyboard

    difficulty rating Difficulty rating:
    time needed Time needed:
    10 minutes activity

    !! These instructions are presented in a general way. Sony VAIO of Europe hereby informs you that the self-replacement of keyboards should be performed with care. If any damage is caused to components of your VAIO while replacing the keyboard, their repair or replacement will be considered as out of warranty and therefore chargeable. !!

    1. Shut down the computer and disconnect all peripheral devices.
    2. Unplug the computer from the AC-Adapter and remove the battery pack.
    3. Touch a grounded metal object to discharge static electricity, for example a radiator or a tap.

    4. Remove 6 screws (marked in red in Figure1).

      Figure 1 - Removing 6 screws from the bottom

    5. Turn the unit around and open it to working position. Tilt the display back as far as it goes without applying any force.

    6. The keyboard is fixed in place by a number of hooks. To release those hooks, slide the keyboard about four millimeters to the left (see figure 2).

      Figure 2 - Position of the keyboard after sliding it to unlock the hooks.

    7. After the keyboard is released, gently lift up the keyboard and then fold it down to the touchpad (see figure 4).

      Figure 3 - Preparing to detach the keyboard from the mainboard

    8. If any tape secures the keyboard flat plastic connector to the connector, carefully peel it off.

    9. Caution:
      • If the keyboard connector is broken, the mainboard needs to be replaced. The cost of replacing the mainboard may exceed the value of a used VAIO.
      The mainboard’s keyboard connector is composed out of two parts: a fixed part (beige) and a bracket (brown), which holds the keyboard's flat cable in place. Carefully unlock the bracket from the connector by pushing gently at it's corners as shown in figure 4.

      Figure 4 - Detaching the keyboard's flat cable

      The keyboard's flat cable should then be free and will slip out of the mainboard's connector without effort.

    10. To install the new keyboard, reverse the procedure while taking note of the following:
      • To avoid unnecessary work, test if the keyboard's flat cable is well connected before continuing with the reassembly. To do so, connect the AC-Adapter to the VAIO, press first the power button and then F2 as soon as the VAIO logo is displayed to enter the BIOS. If that works, switch the VAIO off again, detach the AC-Adapter and proceed with the reassembly.